ELECYLINDER® – Applications & Solutions
EC – Deburring Device for Resin-Molded Products
A device for changing the position of a deburring heater.The heater location can be changed according to the type of the resin-molded product. When an air cylinder was used, the speed was limited to 300 mm/s in order to avoid failures of the heater due to impact at...
EC – Panel Positioning Device
A device for adjusting the transfer position of panels which are flowing on the conveyor.The worker pushes the panel flowing on the conveyor against the stopper for positioning. Drilling is carried out in the next process. The stopper is used to change the stopping...
EC – Transfer Device for Battery Containers
A device for transferring containers filled with battery liquid.This device transfers battery containers under the dispenser and returns them to their original positions after filling. Thanks to the operations with a preset acceleration/deceleration, a stable transfer...
EC – Device for Changing Parts Posture
An air cylinder used to make the parts fall out due to sudden turning. The ELECYLINDER® provides smooth accelerations/decelerations.
EC – Lifting Device of Semi-Finished Products for inspection
A device for lifting semi-finished products during assembling to perform a visual inspection of wiring on the bottom.Lifting up is required because the semi-finished product during assembling cannot be slanted for a visual inspection on the bottom. The ELECYLINDER®...
EC – Door Opening for High-Voltage Inspection Device
A device for opening the door of a voltage inspection device for automobile electronic parts.From the designing stage, the inspection device was presupposed to employ an ELECYLINDER®. The following effects were confirmed: 1) Opening: high speed operation. Closing:...
EC – Inspection Device for Substrate Continuity
A device for inspecting continuity of substrates by using a probe.In the past, an air cylinder was used. However, safety circuit designing for emergency stops (residual voltage, inadvertent leaping out, etc.) and restoring procedures after emergency stops were very...
EC – Operation of Positioning Pins of an Automated Guided Vehicle (AGV)
A device for lifting positioning pins of an automated guided vehicle (AGV).An air cylinder needs a compressor or air piping to be built-in the AGV. However, an ELECYLINDER® needs only simple wiring to operate the lifting device for positioning pins.EC-TW4L ...
EC – Loading for Press Machine
A device for loading metal plates onto a press machine In the past, in order to set the metal plate in the press and push it back, a worker put his hand in the press. Workability has been improved by electrifying the step of pushing into the back with ELECYLINDER®....
EC – Opening Device for Washing Apparatus Door
An opening Device for Washing Apparatus DoorThe air cylinder was previously used to open and close the door, but since the deceleration speed can not be controlled, the door makes hard contact when stopping at the rising and falling ends. Because of this, it was not...
EC – Transfer System for Boxing Cosmetic Bottle
Mechanism for pushing boxes onto the next conveyor connected perpendicularly to the current conveyor An air cylinder was used to transfer packages containing cosmetic bottles between conveyors (connect-ed perpendicularly). However, sometimes the packages fell down due...
EC – Engine Block Part Inspection Process
Mechanism for moving a sensor up and down to measure heights of engine block parts In this process, heights of engine block parts on a conveyor are measured using a height measuring sensor attached to the tip of a rod, to determine whether the parts are good or...