ELECYLINDER® – Applications & Solutions
EC – Loading for Press Machine
A device for loading metal plates onto a press machine In the past, in order to set the metal plate in the press and push it back, a worker put his hand in the press. Workability has been improved by electrifying the step of pushing into the back with ELECYLINDER®....
EC – Opening Device for Washing Apparatus Door
An opening Device for Washing Apparatus DoorThe air cylinder was previously used to open and close the door, but since the deceleration speed can not be controlled, the door makes hard contact when stopping at the rising and falling ends. Because of this, it was not...
EC – Transfer System for Boxing Cosmetic Bottle
Mechanism for pushing boxes onto the next conveyor connected perpendicularly to the current conveyor An air cylinder was used to transfer packages containing cosmetic bottles between conveyors (connect-ed perpendicularly). However, sometimes the packages fell down due...
EC – Engine Block Part Inspection Process
Mechanism for moving a sensor up and down to measure heights of engine block parts In this process, heights of engine block parts on a conveyor are measured using a height measuring sensor attached to the tip of a rod, to determine whether the parts are good or...
EC – Laser Marking System
Inputting work parts to a laser marking system The previous system based on air cylinders presented problems such as diculty ne-tuning the work transfer speed and position. The new ELECYLINDER® system lets us set the product transfer position, A (acceleration), V...
EC – Deburring Device for Plastic Molding Products
A device to perform deburring of inside of lipstick caps. In the past, an air cylinder was used to load parts from the conveyor to the deburring machine and put them back on the conveyor after processing. However, it was not possible to shorten the cycle time because...
EC – Mounting & Dismounting Device of Returnable Box Lids
A device to mount and dismount the lids of returnable boxes in which finished parts are stored. In the past, an air cylinder was used to "remove and put a lid" from/on the returnable box. However, sometimes the lids could not be closed due to dropping of the lid or...
EC – Assembling Device for Electronic Parts
A device to put a cap in a sensor unit assembling process. The ELECYLINDER® uses its push-motion function to put a cap. Compared with an air cylinder, the ELECYLINDER® provides faster approaching speed and a constant pushing force, enabling the cycle time to shorten...
EC – Device for Auto Parts External View
A device to measure thickness by using laser displacement meter. A belt-like laser beam is radiated from a pair of laser measurement devices that are located top and bottom of an automobile part to measure the inner & outer diameters. In this application, a...
EC – Device for Removing Defective Electronic Parts
A device to remove defective electronic parts from the conveyor The movement of the ELECYLINDER® after the sensor's detection of a defective part and a forward-ON signal is faster than that of an air cylinder, enabling the conveyor to increase the speed. EC-S6H ...
EC – Press-fitting Device for Collars to Automobile Shaft Parts
A device to press-fit collars to automobile shaft parts. This is a semi-automated device to press-fit collars on to automobile shaft parts. Previously an air cylinder was used for driving the table. Compressed air was supplied only for the one-axis air cylinder alone....
EC – Cutting Device for Automobile Air Conditioning Parts
A device for cutting automobile air conditioning parts that are blow-molded. Previously, one air cylinder with a cutter was used to cut the parts. In order to increase production, it was operated at a high speed, thus producing cutting defects. Recently ELECYLINDER®...