Kitchen & Others
Application Example: EC – Visual inspection of toilet paper
Replacing an air cylinder with an ELECYLINDER for removing and discharging defective products to the discharging conveyor belt.
Application Example: EC – Printing device for cardboard boxes
Device for printing lot numbers on cardboard boxes for shipment. Replacing an air cylinder with an ELECYLINDER ®, IAI’s New Electric Actuator
EC – Transfer Device of Ashtrays
A device for moving ashtrays horizontally and transferring them to the next process.This device transfers workpieces (ashtrays) to the next process. A motorized ELECYLINDER® was adopted because it was not possible to install a compressor at the site. One of the...
EC – Inspection Device of Bearing Torque
A device for inspecting bearing torqueWith the air cylinder, the speed and acceleration / deceleration were unstable, and there was a defect where the bearing was damaged by the impact of the holding jig. The ELECYLINDER® provides smooth deceleration, exerts no impact...
EC – Deburring Device for Resin-Molded Products
A device for changing the position of a deburring heater.The heater location can be changed according to the type of the resin-molded product. When an air cylinder was used, the speed was limited to 300 mm/s in order to avoid failures of the heater due to impact at...
EC – Gate Cutting Device for Resin-Molded Parts
A device for operating the cutter of a gate cutting machine for resin-molded parts.Compared with an air cylinder, the ELECYLINDER® enables easier fine adjustments of the cutter position. The cutter's tilting movement by the Z-axis is smoother, thus providing a sharp...
EC – Panel Positioning Device
A device for adjusting the transfer position of panels which are flowing on the conveyor.The worker pushes the panel flowing on the conveyor against the stopper for positioning. Drilling is carried out in the next process. The stopper is used to change the stopping...
EC – Device for Changing Parts Posture
An air cylinder used to make the parts fall out due to sudden turning. The ELECYLINDER® provides smooth accelerations/decelerations.
EC – Operation of Positioning Pins of an Automated Guided Vehicle (AGV)
A device for lifting positioning pins of an automated guided vehicle (AGV).An air cylinder needs a compressor or air piping to be built-in the AGV. However, an ELECYLINDER® needs only simple wiring to operate the lifting device for positioning pins.EC-TW4L ...
EC – Loading for Press Machine
A device for loading metal plates onto a press machine In the past, in order to set the metal plate in the press and push it back, a worker put his hand in the press. Workability has been improved by electrifying the step of pushing into the back with ELECYLINDER®....
EC – Opening Device for Washing Apparatus Door
An opening Device for Washing Apparatus DoorThe air cylinder was previously used to open and close the door, but since the deceleration speed can not be controlled, the door makes hard contact when stopping at the rising and falling ends. Because of this, it was not...
EC – Mounting & Dismounting Device of Returnable Box Lids
A device to mount and dismount the lids of returnable boxes in which finished parts are stored. In the past, an air cylinder was used to "remove and put a lid" from/on the returnable box. However, sometimes the lids could not be closed due to dropping of the lid or...