Kitchen & Others
EC – Gripper of a Transfer Device for Mechanical Parts
Used as a gripper of a transfer device to unload parts from processing equipment. In the past, an air cylinder was used, but electrification has been implemented with ELECYLINDER® in order to remove air pipings. EC-R6 » more details
EC – Transfer Device for Transportation Equipment Parts
A device to push out parts on a conveyor to transfer to another conveyor. Because there was no air source, the transfer work was done manually. However, an ELECYLINDER® has made automation possible. Setting of acceleration/deceleration is possible, preventing damages...
EC – Rivetting Device
A device in an assembling process to staking-fasten a main unit and a cover by nylon rivet. Previously nylon rivet was inserted manually by using a hand press in the assembling process, causing occasional inconstant insertions, either too strong or too weak. By...
EC – Dispensing of Adhesive Agent on Mechanical Parts
A device to dispense adhesive agent on mechanical parts by using a dispenser. It is a semi-automatic device to move the dispenser from side to side by operating a switch. In the past, an air cylinder was used. Due to speed fluctuations caused by air pressure changes,...
EC – Winding Device for Cutting Saw Wires
A device to wind up a cutting saw wire after a cutting process. Thanks to winding by a traverse mechanism with ELECYLINDER®, the wire recovery amount has increased. Since long wires can be used, the replacement time has been reduced and throughput has increased....
EC – Posting Device for Stickers
A device to push down thin-film stickers on the workpieces in a posting process. In the past, a worker used to press the stickers to post them manually. To improve the quality and eliminate mistakes by workers, some measures were studied. An air cylinder provides...
EC – Dispensing Device
Changing the angle of a spray gun. By changing the linear motion to a swaying motion of an ELECYLINDER® rod type, the dispensing spray gun changes its angle to perform dispensing. The speed and work range of the spray gun can easily be changed, allowing dispensing...
EC – In-House Training Apparatus for Safety Device
An apparatus to experience and learn the effect of the safety device as part of a safety training. There was an accident in the past, in which a worker disabled the safety device without permission and got injured. In order to prevent such an accident from recurring,...
Easy Automation Concept Vol.9-2 Videos #18
Example Video #18: Gear Shaft Press-fitting System - Air cylinder vs IAI's ROBO Cylinder Achieving 0% defect rate by shortening the cycle time and changeover time through optimal settings. This is a process for assembling gear parts with shafts for toys. A metal shaft...
Easy Automation Concept Vol.5 Videos
Example Video #09: Frame Bonding System - Air cylinder vs IAI's ROBO Cylinder This system produces frames by bonding resin parts. A total of four locations are bonded. Adhesive is applied to the end faces of resin frame parts. Then, the end faces of the frame parts...
Easy Automation Concept Vol.4-2 Video #08
Example Video #08: Glass Board Work Piece Transfer System - Air cylinder vs IAI's ROBO Cylinder Glass boards are placed on a pallet in this process. 16 work pieces are placed in lines on one pallet. The deburring brush attached to the motorized spindle*2 is used to...
Easy Automation Concept Vol.4 Videos
Example Video #07: Deburring System - Air cylinder vs IAI's ROBO Cylinder This system removes burrs around holes drilled in a pulley*1. Eight locations are deburred. The deburring brush attached to the motorized spindle*2 is used to remove the burrs along the edge of...