ELECYLINDER® – Applications & Solutions
EC – Transfer Device of Ashtrays
A device for moving ashtrays horizontally and transferring them to the next process.This device transfers workpieces (ashtrays) to the next process. A motorized ELECYLINDER® was adopted because it was not possible to install a compressor at the site. One of the...
EC – Inspection Device of Bearing Torque
A device for inspecting bearing torqueWith the air cylinder, the speed and acceleration / deceleration were unstable, and there was a defect where the bearing was damaged by the impact of the holding jig. The ELECYLINDER® provides smooth deceleration, exerts no impact...
EC – Transfer Device for Stacked Frozen Food Packs
A device for stacking and transferring frozen food packs to the conveyor of the next process.This device transfers frozen gyoza dumplings from the wrapping process to the next process of packing into cardboard boxes. Packs are dropped from the conveyor by free fall,...
EC – Assembling Device of Automobile Interior Parts
A process to assemble parts on a resin-made frame.The "push function" of the ELECYLINDER® has enabled air-less and sensor-less operations. As the push motion is applied on an assembled part, the ELECYLINDER® detects the torque and outputs a "push motion complete"...
EC – Feeding Device of Paper Carton Materials
A device for feeding paper carton materials to the next process.The workpieces (before formed into paper liquid packs) stacked by the ELECYLINDER® are lifted up to the predetermined position. The sensor detects the top of the stacked workpieces and stops the lifting....
EC – Gate Cutting Device for Resin-Molded Parts
A device for operating the cutter of a gate cutting machine for resin-molded parts.Compared with an air cylinder, the ELECYLINDER® enables easier fine adjustments of the cutter position. The cutter's tilting movement by the Z-axis is smoother, thus providing a sharp...
EC – Deburring Device for Resin-Molded Products
A device for changing the position of a deburring heater.The heater location can be changed according to the type of the resin-molded product. When an air cylinder was used, the speed was limited to 300 mm/s in order to avoid failures of the heater due to impact at...
EC – Panel Positioning Device
A device for adjusting the transfer position of panels which are flowing on the conveyor.The worker pushes the panel flowing on the conveyor against the stopper for positioning. Drilling is carried out in the next process. The stopper is used to change the stopping...
EC – Transfer Device for Battery Containers
A device for transferring containers filled with battery liquid.This device transfers battery containers under the dispenser and returns them to their original positions after filling. Thanks to the operations with a preset acceleration/deceleration, a stable transfer...
EC – Device for Changing Parts Posture
An air cylinder used to make the parts fall out due to sudden turning. The ELECYLINDER® provides smooth accelerations/decelerations.
EC – Lifting Device of Semi-Finished Products for inspection
A device for lifting semi-finished products during assembling to perform a visual inspection of wiring on the bottom.Lifting up is required because the semi-finished product during assembling cannot be slanted for a visual inspection on the bottom. The ELECYLINDER®...
EC – Inspection Device for Substrate Continuity
A device for inspecting continuity of substrates by using a probe.In the past, an air cylinder was used. However, safety circuit designing for emergency stops (residual voltage, inadvertent leaping out, etc.) and restoring procedures after emergency stops were very...